1190 Series
Low Temperature Waterborne Acrylic Traffic Paint
1190 Series is a low temperature, 100% acrylic waterborne traffic paint that can be applied at temperature as low as 35°F. This product is designed to offer quick dry at low temperature application where standard paints would not.
1190 Series is recommended for striping long line traffic markings on roads and highways, or other traffic surfaces including parking lots, driveways, sidewalks and runways. It may be applied over asphalt, Portland cement and concrete pavement.
ADVANTAGES
- Can be applied at temperature as low as 35°F.
- Extended striping season for increased productivity.
- Good performance.
- Quick dry at low application temperatures.
- Improved adhesion to oily surfaces.
- Exceptional flexibility.
- Can be applied with conventional or airless spray equipment.
- No thinning for application.
| Property |
1190 |
1196 |
Other Colors |
|
Pigment, |
61 |
61 |
61 |
|
Total Solids |
77 |
77 |
77 |
|
Nonvolatile Vehicle |
41 |
41 |
41 |
|
Weight |
13.9 |
13.6 |
13.5 |
|
Viscosity |
80-95 |
80-95 |
80-95 |
|
Grind (Hegman Gauge) |
4 |
4 |
4 |
|
Contrast Ratio |
0.95 |
0.90 |
0.90 |
|
Directional Reflectance |
90 |
50 |
NA |
|
Dry Through Time |
125 |
125 |
125 |
|
No Pick Up Time, |
8 |
8 |
8 |
| Thinner |
Water |
Water |
Water |
| VOC g/l, Max |
100 |
100 |
100 |
| Packaging |
1 gallon can |
||
| Coverage |
100 square feet per gallon at 15 mil wet film 300 linear feet of 4“ line per gallon at 15 mil wet film. |
||
SURFACE PREPARATION
In general, coating performance is in direct proportion to the quality of the surface preparation. Before applying coatings, the surface should be clean and dry. The surface must be free of oil, grease, gasoline and moisture.
APPLICATION
- Do not apply when the temperature is below 30°F.
- Do not heat coating in striping system above 110°F.
- Do not apply first coat over fresh asphalt at more than 7 mils wet.
- Allow first coat to dry before applying second coat.
- New asphalt and concrete must be allowed to cure for a minimum of 30 days before application of product.
- Do not leave water or water mixed with non-subsiding cleaner for more than 24 hours in spray equipment. It is recommended to use a mixture of glycol solution and water for storing spray equipment longer than 72 hours.
- Surface temperature must be at least 5°F above dew point to prevent condensation.
- DO NOT MIX WITH WATER. This product comes ready mixed.
GOVERNMENT SPECIFICATIONS
-
Meets Federal Std. 141D and American Standard
Test Method (ASTM) - Meets FS TTP-1952E
MIXING
To get an even coverage of paint pigment, the paint should be agitated for 10-15 minutes. If necessary, strain the paint and remove any skins before mixing. Do not attempt to mix hardened paint films with liquid paint
ENVIRONMENTAL
Meets SCAQMD Rule 1113.
Dry paint chips are non-toxic
Meets Federal Clean Air Act Regulations
CLEAN UP
Immediately clean all equipment after use with fresh water to remove any partially dried material. If paint is dry, a solvent may be necessary but be careful not to contaminate this and all waterborne paints with solvents.
SAFETY PRECAUTIONS
For industrial use only. Not for residential use. See and read MSDS and product labels before use. Safety precautions must be strictly followed during storage, handling and use.
SHELF LIFE
Water base paints are best utilized within 3 months of delivery but remains usable for 12 months.
WARRANTY
Colorado Paint warrants to the purchaser, for 6 months from the date of manufacturing, that this product when applied according to Colorado Paint Application Instructions, shall be manufactured without defects. This limited warranty covers material replacement only. Excluded from coverage is labor, any damage to the application surface or any failure of the coating caused other than by defects in the material.